This was a total of 85 plugins, and used 98% of the DSP and 24% of the PGM resources.Īfter about 15 plete lockup. This ran for some time, so I decided to double the plugin count and managed to have 2 1176LN and 2 Pultec Pro on the first 17 channels. I then duplicated the session using the 1176LN and Pultec-Pro (which are licensed plugins) to see if the problem would appear. This ran for over an hour with no problems. I loaded up a 24 track, audio only session in Logic 8.0.2 and using only the included "Mix Essentials" plugins, I assigned a single 1176SE and Pultec to each channel. Tech support at UA suggested that the problem may stem from authorization oddness, so. If moving the value UP or DOWN negatively effects your system then go back to the default value of 64." Don't forget to close the audio application.THEN make the adjustment to the UAD.THEN open the audio application again. If it does not help you can try adjusting the other way (decrease MIN-GNT value). Once you make the adjustment open the audio application run a session and see if this helps. NOTE: Make sure you do this with your audio application closed. Try to increate the MIN_GNT setting from 64 (default) to 128. The MIN_GNT adjusts the priority of the PCI bus and may help to 'integrate' the UAD with your host app. Experiment with MIN_GNT settings in the UAD Meter / File / Configuration. Also try system sound (Mac sound) to see if the same errors occur. In the Configuration Window uncheck the 'Extra buffering' if it is currently selected/checked. You should try changing the 'Process Buffer Range' to Large. You can adjust the CORE AUDIO settings in Logic. There are a few suggestions zmix has not tried in his list: This is what UAudio Macsupport suggested I try earlier this week, when I was having severe system lockup problems. Re: Things I have tried to get my UAD-2 to not crash my Mac "Check LED status and report to Universal Audio" " One or more UAD plugins have been disabled" system locked up after 30 minutes and only the outer 2 of the three LEDs were blinking.Īnd again with all three blinking, but an error message: Installed the UAD-2 in several different slots in the G5 motherboard,Ĭhanged "Process Buffer" size setting in Logic audio driver dialog.Įnabled / Disabled "DSP Loadlock" and "Extra buffering" on UAD meter, rebooted system (once for each setting).Įnabled / Disabled "Force Logic to use Live mode for tracks with UAD-1 (sic) plugins"ĭe-selected "Release all DSP resources on Audiounit bypass"ĮDIT: Temporarily. Things I have tried in an effort to remedy my UAD-2 system freezes:Īll of this was tried on my G5 Quad 2.5G under OSX 4.11 and running Logic 7.2.3 and Logic Pro 8.0.2Ĭomplete uninstall of the v5.0 software, removed both the UAD-1 and UAD-2 cards from my system, ran all maintenance routines and reinstalled the drivers and software, rebooted, powered down and reinstalled the two cards.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |